Hardware Problems; The Display Does Not Work - HP D5970A - NetServer - LCII User Manual

Chapter 6
3. Plug in the power cord, and turn on power to the HP NetServer. The
message
Configuration has been cleared, set Clear Config
switch to the OFF position before rebooting
is displayed.
4. Turn off power to the HP NetServer, and unplug the power cord.
5. Return switch 5 on the system board to the OFF position.
6. Replace the system board, the top cover, and the front bezel, and plug in
the power cord.
7. Turn on power to the HP NetServer. The error message
0012-34 : Incorrect System Configuration
may be displayed. If the error message above is displayed, it is followed by
the explanation
The BIOS has detected a serious problem that
prevents your PC from booting
This is normal.
8. Press the F2 key to run the Setup utility.
9. Make any configuration changes that are required.
10. Press the F10 function key and answer "Yes" to save the configuration and
exit the Setup utility.

Hardware Problems

This section describes what to do if you have problems with your display, mass
storage devices, printer, accessory boards, keyboard, or mouse.

The Display Does Not Work

NOTE If the HP NetServer has a large amount of memory installed, it
may take one minute for the first screen to display.
1. If nothing is displayed on the screen, but the computer starts and, the
keyboard, flexible disk drive, other disk drives, and other peripheral
devices seem to operate properly, do the following:
Check that the monitor is plugged in and power is turned on.
Troubleshooting
53