Remove The System Board - HP D5970A - NetServer - LCII User Manual

Chapter 1

Remove the System Board

If you are adding additional memory, remove the system board first. Use the
retaining latches to start lifting the system board. Grasp the metal bracket at the
top of the system board, and lift the system board straight up and out of the HP
NetServer, as shown in Figure 1-2.
Lay the system board component-side up on a static-dissipating work surface
with the metal cross piece on the top rear corner of the system board extending
off the work surface, as shown in Figure 1-3.
6
Figure 1-2. Remove the System Board
Installation Overview