Install Additional Mass Storage Devices; Replace All Covers And Connect All Cables - HP D5970A - NetServer - LCII User Manual

Chapter 1
e. Configuration Advisor displays the Configuration Advisories. You can
print them out by saving them to disk (diskette) and later printing out
from the diskette.
Read the documentation supplied with the accessory boards. If you are installing
an ISA non-plug-and-play board, write down the switch and jumper settings and
all system resource requirements (such as memory range, I/O port range, DMA
channel, and IRQ level). Refer to these notes when you allocate system resources
to the ISA non-plug-and-play board when you configure the HP NetServer.

Install Additional Mass Storage Devices

Certain mass storage configurations may require additional cables or adapters.
For part numbers for HP cables, adapters, and trays, and configuration
information, see Information Assistant on the HP Navigator CD-ROM. For new
products, you can use Order Assistant on the HP Web Site at
http://www.hp.com/go/netserver. Click the hot spot "Ordering NetServers" and
choose your desired option.

Replace All Covers and Connect All Cables

Refer to Figure 1-6 and replace all covers.
CAUTION
Covers are necessary for proper air flow through the system.
Please replace ALL covers before operating the HP
NetServer, even for a short time. Otherwise, overheating can
damage processors, boards, and mass storage devices.
Installation Overview
11