HP D5970A - NetServer - LCII User Manual page 46

Chapter 5
9. Insert one M4 button-headed screw through the filler panel and into the
threaded insert in the sliding shelf of the base assembly.
10. Insert one cosmetic screw through the flange on the left sliding shelf and
into the rack nut you positioned there in step 3.
11. Prepare each HP NetServer LC 3 for mounting in the rack.
WARNING Extend the anti-tip foot from the front lower section of the
rack before placing the LC 3 on the base assembly. Also
ensure the leveler screws at each corner are in firm contact
with the floor.
Turn off and disconnect the HP NetServer from power and telephone.
Remove the covers of the LC 3 as discussed in Chapter 1, "Remove the
Covers."
WARNING
Always disconnect the power cord and unplug telephone
cables. Doing so prevents any possibility for electrical burns
or exposure to high energy levels.
12. Be sure the anti-tip foot and the leveler screws are fully extended to
prevent the rack from rolling away or tipping over. Get help to lift the
NetServer onto the right side of the extended base unit, as shown in
Figures 5-4 and 5-5.
40
Installation in Rack (Optional)