Installing Memory - IBM NetVista Hardware Maintenance Manual

The following illustration shows the locations of parts on the system board.
1 Microprocessor
2 DIMM connector 1
3 DIMM connector 2
4 Power connector
5 Diskette drive connector
6 Primary IDE connector
7 Front panel connector
8 Secondary IDE connector

Installing memory

Your computer has two connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 2.0 GB of system memory.
When installing DIMMs, the following rules apply:
v Fill each system memory connector sequentially, starting at DIMM connector 1.
v Use 2.5 V, 184-pin, 266MHz double data rate synchronous dynamic random
access memory (DDR SDRAM).
v Use 128 MB, 256 MB, 512 MB, or 1.0 GB (when available) DIMMs in any
combination.
v DIMMs are 38.1 mm (1.5 inches) in height.
Note: Only DDR SDRAM DIMMs can be used.
To install a DIMM:
1. Remove the cover. See "Removing the cover" on page 23.
2. You might have to remove an adapter to gain access to the DIMM slots. See
"Installing adapters" on page 27.
9 Battery
10 Clear CMOS/Recovery jumper
11 SCSI LED connector
12 PCI slots
13 Front panel audio connector
14 CD-ROM audio connector
15 AGP slot (some models)
16 Serial connector
Chapter 5. Installing Options
25