Table of Contents
Advertisement
The following illustration shows the locations of parts on the system board.
1 Fan connector
2 Microprocessor
3 DIMM connector 1
4 DIMM connector 2
5 Power connector
6 Hard disk LED connector
7 Power LED connector
8 Diskette drive connector
Installing memory
The computer has three connectors for installing dual in-line memory modules
(DIMMs) that provide up to a maximum of 512 MB of system memory.
Installing and removing DIMMs
When installing DIMMs, the following rules apply:
v Fill each system memory connector sequentially, starting at DIMM 1
v Use 3.3 V, synchronous, 168-pin, unbuffered, 133 MHz nonparity synchronous
dynamic random access memory (SDRAM)
v Use 64 MB, 128 MB, or 256 MB DIMMs in any combination
v DIMM heights of 38.1 mm (1.5 inches)
To install a DIMM:
1. Remove the cover. See "Removing the cover" on page 23.
2. You might have to remove an adapter to gain access to the DIMM slots. See
"Installing and removing adapters" on page 27.
9 Secondary IDE connector
10 Primary IDE connector
11 Front USB connector
12 Battery
13 Virtual clear CMOS/BIOS recovery
jumper (JP14)
14 PCI slots
15 CD-ROM audio connector
16 Front panel connector
Chapter 5. Installing Options
25
Advertisement
Table of Contents
