Table of Contents
Advertisement
IBM NetVista
Options Installation
Installing Memory Modules
For this system board, you must use 168-pin 3.3V non-buffered Dual In-line Memory
Modules (DIMMs). The memory chips are standard SDRAM (Synchronous Dynamic
Random Access Memory). The table below shows the supported frequencies.
Frontside Bus
(FSB)
Frequency
100 MHz
100 MHz
Installation Procedure
The system board accommodates three memory modules. You must install at
least one module in any of the three slots. Each module can be installed with 64
MB to 512 MB of memory. Total capacity is 3GB.
1.
Align the memory module with the slot. The DIMM slots are
keyed with notches and the DIMMs are keyed with cutouts so
System Memory
Bus (SMB)
Frequency
100 MHz
133 MHz
21/53
Advertisement
Table of Contents
