Installing And Configuring An Snmp Agent On Solaris - Lenovo ThinkServer RD330 Software User's Manual
Megaraid sas software user guide
Hide thumbs
Also See for ThinkServer RD330:
- Safety information manual (288 pages) ,
- Benutzerhandbuch (212 pages) ,
- Guía del usuario (202 pages)
Table of Contents
Advertisement
Chapter 6: MegaRAID Storage Manager Overview and Installation
ing an SNMP Agent
6.7.3
Installing and Configuring an
SNMP Agent on Solaris
6.7.3.1
Prerequisites
6.7.3.2
Installation SNMP on
Solaris
6.7.3.3
SAS SNMP MIB
Location
6.7.3.4
Starting, Stopping, and
Checking the Status of the SAS
SNMP Agent
Page 244
|
Installing and Configur-
NOTE: It is assumed that snmpd.conf is located at /etc/snmp for Red Hat and /etc for
SLES. You can change the file location from /etc/init.d/lsi_mrdsnmpd file.
You can install SNMP without the trap functionality. To do so, set the "TRAPIND"
environment variable to "N" before running RPM.
Before you install a new version, you must uninstall all previous versions.
For SLES 10, perform the following steps to run SNMP:
1. Copy /etc/snmp/snmpd.conf to /etc/snmpd.conf.
2. Modify the /etc/init.d/snmpd file and change
SNMPDCONF=/etc/snmp/snmpd.conf entry to SNMPDCONF=/etc/snmpd.conf.
3. Run LSI SNMP rpm.
This section explains how to install and configure SAS SNMP Agent for the Solaris
operating system.
This package requires that you have Solaris System Management Agent installed on
the Solaris machine.
To install SNMP for Solaris, perform the following procedure:
1. Unzip the SAS SNMP Agent package.
2. Run the install script by executing the following command:
# ./install.sh
NOTE: The installation will exit if there are any existing versions of storelib and sassnmp
installed on the Solaris machine. Uninstall the existing version by using the following
commands:
# pkgrm storelib (to uninstall storelib library)
# pkgrm sassnmp (to uninstall SAS SNMP Agent)
After you install the SAS SNMP Agent package, the MIB file
LSI-AdapterSAS.mib is installed under /etc/lsi_mrdsnmp/sas directory.
The following commands are used to start, stop, restart, and check the status of the
Solaris System Managment Agent (net snmpd) daemon:
Start: # svcadm enable svc:/application/management/sma:default
Stop: # svcadm disable svc:/application/management/sma:default
Restart: # svcadm restart svc:/application/management/sma:default
Status: # svcs svc:/application/management/sma:default
NOTE: Online indicates that the SMA is started. Disabled indicates that the SMA is
stopped.
MegaRAID SAS Software User Guide
Advertisement
Table of Contents
