Prerequisites To Running Msm Remote Administration - Lenovo ThinkServer RD330 Software User's Manual

Chapter 6: MegaRAID Storage Manager Overview and Installation
MSM Remote Administration
6.9 Prerequisites to Running
MSM Remote Administration
Page 248
|
Prerequisites to Running
NOTE: To start the Framework service, run svcadm enable MSMFramework. To start
the monitor service run svcadm enable MSMMonitor.
NOTE: When the service is in "maintenance state", run "svcadm clear MSMFramework"
and "svcadm clear MSMMonitor. "
NOTE: To check the status of MSM services execute the command svcs -a | grep
-i msm.
MSM requires ports 3071 and 5571 to be open to function. Follow these steps to
prepare to run MSM Remote Administration.
1. Configure the system with valid IP address.
Make sure there is no IP address conflict with in the sub network.
Ports such as 3071 and 5571 are open and available for MSM framework
communication.
2. Disable all security manager and firewall.
3. Configure the multicasting.
Make sure Class D multicast IP addresses are registered (at least 229.111.112.12
should be registered for MSM to work); if not, create a static route using the
following command:
Route add 229.111.112.12 dev eth1
4. Install MSM. If MSM is already installed, restart MSM framework.
MegaRAID SAS Software User Guide