Table of Contents
Advertisement
6. MOUNTING AND INSTALLATION
Cautions:
For added protection mount the fixtures in areas outside walking paths, seating areas, or in
areas were the fixture might be reached by unauthorized personal.
Before mounting the fixture to any surface, make sure that the installation area can hold a
minimum point load of 10 times the device's weight.
Fixture installation must always be secured with a secondary safety attachment, such as an
appropriate safety cable.
Never stand directly below the device when mounting, removing, or servicing the fixture.
Mounting
The Design Wash LED 60
upside-down from a ceiling, or set on a flat level surface (see illustration on the next page).
Be sure this fixture is kept at least 0.5m (1.5 feet) away from any flammable materials
(decoration etc.). Always use and install the supplied safety cable as a safety measure to
prevent accidental damage and/or injury in the event the clamp fails.
©Elation Professional, Los Angeles Ca.
Caution!
When install the fixture be sure there is no highly inflammable
material within a distance of .5m (1.5 feet)
™
is fully operational in two different mounting positions, hanging
Refer to regulations BGV C1 (formerly VBG 70) and DIN VDE0711-217
for proper installation in Europe To ensure proper installation, only
qualified staff should attempt installation.
12
Design Wash LED 60™
www.ElationLighting.com
Advertisement
Table of Contents
