Util1 System Settings; Util1-1 Master Volume Page; Util1-2 Master Tune Page; Util1-3 Startup Kit Page - Yamaha DTX-MULTI Owner's Manual

UTIL1 GENERAL
System Settings
UTIL1
≥≥≥≥GENERAL
In the GENERAL section, you can set parameters affecting the
entire system. With the GENERAL page (UTIL1) displayed,
press the [ENTER] button to access its eight parameter-setting
pages (UTIL1-1 to UTIL1-8). You can use the [B]/[C] buttons
to navigate between these pages.
Master Volume page
UTIL1-1
UTIL1-1<GENERAL>
MasterVolume=127
1 Master volume
Use this parameter to set the master volume of the instru-
ment's internal tone generator. If a small value is set here, the
VOLUME dial on the front panel will have very little effect in
increasing the output volume.
Settings 0 to 127
Master Tune page
UTIL1-2
UTIL1-2≥≥M.Tune=
+≥≥0.0(440.0Hz)
1
1 Master tune (M.Tune)
Use this parameter to tune (i.e., adjust the basic pitch of) the
internal tone generator. The value in parentheses shows the
corresponding tuning (of A above middle C) in Hertz.
Settings -102.4 to +0.0 to +102.3
NOTE
• The term "cent" refers to one hundredth of a semitone (i.e., 100 cents
= 1 semitone).
Startup Kit page
UTIL1-3
UTIL1-3<GENERAL>
StartupKit=P001
1 StartupKit
Use this parameter to specify the kit to be automatically
selected when the DTX-MULTI 12 is turned on. Kits are
identified using a category (P for Preset, U for User) and a
number, and you can move the cursor using the [B]/[C]
buttons to set these individually.
Settings P001 to P050 or U001 to U200
UTIL1-4
1 Startup pattern (StartupPtn)
Use this parameter to select the pattern that will be automati-
cally set when the DTX-MULTI 12 is turned on. Patterns are
identified using a category (eP for Preset, eU for User) and a
number, and you can move the cursor using the [B]/[C]
buttons to set these individually.
Settings
UTIL1-5
1
1 Startup trigger (StartupTrg)
Use this parameter to select the trigger setup that will be auto-
matically selected when the DTX-MULTI 12 is turned on.
Trigger setups are identified using a category (P for Preset, U
for User) and a number, and you can move the cursor using
the [B]/[C] buttons to set these individually.
Settings
UTIL1-6
1 Variation effect (var)
B Chorus effect (cho)
C Reverb effect (rev)
Use these parameters to specify which effects will be
bypassed when Effect Bypass is activated from the front panel
(using the [SHIFT] and [KIT] buttons). When "---" is selected
for an effect type, it will not be bypassed.
Settings
1
UTILITY Setting Area (UTIL)
Startup Pattern page
UTIL1-4<GENERAL>
StartupPtn=©P001
eP001 to eP128 or eU001 to eU050
Startup Trigger page
UTIL1-5<GENERAL>
≥StartupTrg=P01
P01 to P05 or U01 to U10
Effect Bypass page
UTIL1-6≥≥FXByps=
≥≥var/cho/rev
1 2 3
---/var, ---/cho, or ---/rev
1
1
83
Owner's Manual