Kit6 Reverb Effect Setup - Yamaha DTX-MULTI Owner's Manual

KIT Setting Area (KIT)
Chorus Pan page
KIT5-3
KIT5-3≥≥≥≥≥<CHO>
≥≥≥ChoPan=≥C
1 Chorus pan (ChoPan)
Use this parameter to set the stereo panning of the chorus
effect's return signal.
Settings L63 to C to R63
Chorus to Reverb page
KIT5-4
KIT5-4≥≥≥≥≥<CHO>
≥≥ChoToRev=≥≥0
1 Chorus to reverb (ChoToRev)
Use this parameter to set the degree to which the output from
the chorus effect is sent to the reverb effect.
Settings 0 to 127
KIT6 REVERB
Reverb Effect Setup
KIT6
≥≥≥≥≥REVERB
In the REVERB section, you can select a reverb effect and config-
ure it in a range of different ways. Reverb effects are applied to all
voices (on all MIDI channels). With the REVERB page (KIT6)
displayed, press the [ENTER] button to access its three parame-
ter-setting pages (KIT6-1 to KIT6-3). You can use the [B]/[C]
buttons to navigate between these pages.
50
Owner's Manual
KIT6-1
1
1 Reverb type
Use this parameter to select a reverb-effect type.
Settings
With a reverb type selected, you can press the [ENTER] button on
the Reverb Type page (KIT6-1) to access a range of setting pages
allowing each of its parameters to be set. (The number of parame-
ter-setting pages depends on the type selected.) Use the [B]/[C]
buttons to navigate between these pages.
KIT6-1-1
1
1 Effect parameter
Each parameter setting page contains a different parameter for
the selected reverb type.
Settings
KIT6-2
1 Reverb return (RevReturn)
Use this parameter to set the level of the return signal from the
reverb effect.
Settings
KIT6-3
1 Reverb pan (RevPan)
Use this parameter to set the stereo panning of the reverb
effect's return signal.
Settings
Reverb Type page
KIT6-1≥≥RevType=
R3≥Hall
Refer to the separate Data List booklet.
Parameter setting page (example)
KIT6-1-1≥≥≥<REV>
RevTime=≥0.0s
Refer to the separate Data List booklet.
Reverb Return page
KIT6-2≥≥≥≥≥<REV>
≥RevReturn=≥64
0 to 127
Reverb Pan page
KIT6-3≥≥≥≥≥<REV>
≥≥≥RevPan=≥C
L63 to C to R63
1
1
1
1