Xerox 6030 User Manual page 41

<Hardware error has occurred.>
Cause Fatal hardware error has occurred for unknown reasons.
Solution
<Cannot change operation mode. Pull out original and click [OK]. >
Cause User tried to change operation mode while it is unavailable.
Change operation mode after 30 seconds.
Solution
<Cannot change operation mode. Pull out original and click [OK]. >
Cause User tried to change operation mode while document is
jammed and operation mode cannot be changed.
Solution Remove jammed document and press [OK].
<Cannot use scanner. Check SCSI connection and Scanner control panel display.>
Cause No device available.
Solution Connect available device.
<Power-off or reset has occurred.>
Cause Power-off or reset has occurred.
Solution
<Document size including specified offset is beyond allowable setting range.
Change offset, document size, or resolution.>
Cause The combination of offset, document size, resolution value is
inappropriate.
Solution Change specified value.
<Cannot read document with specified resolution.>
Cause Resolution specified in standard size custom specification
mode cannot be used for scanning the specified document.
Solution Change resolution value or document size.
4.1 Error and Warning messages
31