Input Source Selection (Component, Rgb Scart 21-Pin) - Eiki LC-XB28 Owner's Manual

Input Source Selection (Component, RGB Scart 21-Pin)

Direct Operation
Choose Computer 1 by pressing the INPUT button on the
top control or press the COMPUTER button on the remote
control.
Before using these buttons, correct input source should be
selected through menu operation as described below.
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Press the Point 7 8 buttons to move the red
frame pointer to the Input Menu icon.
2
Press the Point d button to move the red arrow
pointer to Computer 1, and then press the SELECT
button. The Source Select Menu will appear.
3 Move the pointer to the correct input source and then
press the SELECT button.
When the input source is coming from
Component
video equipment connected to the
COMPUTER IN 1/ COMPONENT IN
terminal with a Component-VGA Cable,
select Component.
When the input source is coming from
RGB (Scart)
video equipment connected to the
COMPUTER IN 1/ COMPONENT IN
terminal with a Scart-VGA Cable, select
RGB (Scart).
✔
Note:
• Component-VGA Cable and Scart-VGA Cable are optionally
supplied. See page 58 for order.
• Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is used as Monitor out. (p41)
INPUT button
Top Control
ON - OFF
POWER
INPUT button
INPUT
WARNING
KEYSTONE
LAMP
REPLACE
SELECT
Remote Control
COMPUTER button
COMPUTER button
ON - OFF
COMPUTER VIDEO OFF
VOLUME - VOLUME +
MENU SELECT
✳ See Note at the bottom of this page.
Input Menu icon
D.ZOOM PAGE KEYSTONE NO SHOW
Input Menu
P - TIMER
AUTO PC
IMAGE FREEZE MUTE
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Computer
1
Source Select Menu
Move the pointer to
Component or RGB
(Scart) and press the
SELECT button.
Video Input
Computer 1
✳
Computer 2
Video
Computer 1
✳
Computer 2
33