Computer Input; Input Source Selection - Eiki LC-XB28 Owner's Manual

Computer Input

Input Source Selection

Direct Operation
Choose either Computer 1 or Computer 2 by pressing the
INPUT button on the top control or press the COMPUTER
button on the remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
Menu Operation
1 Press the MENU button to display the On-Screen
Menu. Press the Point 7 8 buttons to move the red
frame pointer to the Input Menu icon.
2
Press the Point d button to move the red arrow
pointer to either Computer 1 or Computer 2, and then
press the SELECT button.
3 After the Source Select Menu appeared for Computer
1, move the pointer to RGB and then press the
SELECT button.
When the input source is analog coming
RGB
from a computer through the COMPUTER
IN 1/ COMPONENT IN terminal, select
RGB.
See "Input Source Selection (Component /
Component
RGB-Scart 21-pin )" on p33.
See "Input Source Selection (Component /
RGB (Scart)
RGB-Scart 21-pin )" on p33.
✔Note:
Computer 2 is not displayed when the COMPUTER IN 2/
MONITOR OUT terminal is used as Monitor out. (p41)
24
INPUT button
Top Control
ON - OFF
POWER
INPUT button
INPUT
WARNING
KEYSTONE
LAMP
REPLACE
SELECT
Remote Control
COMPUTER button
COMPUTER button
ON - OFF
COMPUTER VIDEO
MENU VOLUME - SELECT VOLUME +
✳ See Note at the bottom of this page.
Input Menu icon
D.ZOOM PAGE KEYSTONE NO SHOW
Input Menu
P - TIMER
AUTO PC
IMAGE FREEZE MUTE
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Computer
1
Source Select Menu
Move the pointer to RGB
and press the SELECT
button.
Input Menu
Move the pointer (red
arrow) to Computer 2 and
press the SELECT button.
Computer 1
✳
Computer 2
Video
Computer 1
✳
Computer 2