Power On Self Test And Ip Address Setup; Successful Self-Test; Self-Test Failure - Cisco VG30D User Manual

Power On Self Test and IP Address Setup

Power On Self Test and IP Address Setup
On power ON of the Cisco VG30D Voice Gateway, the unit will perform a self-test. The Power LED on
the front panel shows amber, and the four STATUS LEDs come on and go off (in sequence from left to
right) to indicate that the unit is performing the self-test. These tests check the correct operation of the
hardware and start the operational software. This process should complete in less than 1 minute.

Successful Self-Test

When all the tests complete successfully
amber to green. Approximately 30 seconds later, you can log in to the web-based Gateway Management
Interface.
The Cisco VG30D Voice Gateway has been configured with the default IP address of 192.168.1.1 and
sub-net mask 255.255.255.0.
Proceed
Connect the ethernet port of the Cisco VG30D Voice Gateway directly to the ethernet port of a computer.
Step 1
Open a web browser and enter 192.168.1.1 directly into the IP address bar.
Step 2
Note
Log in to the Cisco VG30D Voice Gateway by using Advanced (case sensitive) for both Username and
Step 3
Password.
Browse to Configuration/Gateway/Set IP Address.
Step 4
Set Gateway Management IP Address, Set Gateway Management Subnet Mask and, if required, Set
Step 5
Management Default Gateway Address and click the Submit button.
Note
The Cisco VG30D Voice Gateway may now be powered OFF, installed and connected to the IP network
(accessible through the new IP address). As an alternative, you may continue with further configuration
using the Gateway Management Interface as described in Sections
Gateway User Guide.

Self-Test Failure

If any test in the sequence fails, the cycle of the STATUS LEDs will stop (with one LED remaining on)
and the Power LED will remain AMBER.
Cisco VG30D Voice Gateway User Guide
2-6
as follows:
You may need to change the IP address and sub-net mask of your computer to be on the same
sub-net.
The set parameters will get used next time that the Cisco VG30D Voice Gateway gets re-booted,
but the Cisco VG30D Voice Gateway will remain accessible through the active connection until
then.
and the software is operational, the Power LED ch
Chapter 2 Installation
anges colour from
3 and 4 of the Cisco VG30D Voice
OL-19276-01