Power On Self Test And Ip Address Setup; Successful Self-Test - Cisco VG30D Quick Start Manual

Power On Self Test and IP Address Setup

Successful Self-Test

Step 1
Step 2
Step 3
Step 4
Step 5
78-19034-01
On powering ON the Cisco VG30D Voice Gateway, the unit will perform a
self-test. The Power LED on the front panel shows amber, and the four STATUS
LEDs come on and go off (in sequence from left to right) to indicate that the unit
is performing the self-test. These tests check the correct operation of the hardware
and start the operational software. This process should complete in less than 1
minute.
When all the tests have completed successfully
anges colour from amber to green. Approximately 30 seconds later,
Power LED ch
you can log in to the web-based Gateway Management Interface.
The Cisco VG30D Voice Gateway configuration includes the default IP address
of 192.168.1.1 and sub-net mask 255.255.255.0.
Proceed
as follows:
Connect the ethernet port of the Cisco VG30D Voice Gateway directly to the
ethernet port of a PC.
Open a web browser and enter 192.168.1.1 directly into the IP address bar.
You may need to change the IP address and sub-net mask of your
Note
computer to be on the same sub-net.
Log in to the Cisco VG30D Voice Gateway by using Advanced (case sensitive)
for both Username and Password.
Browse to Configuration/Gateway/Set IP Address.
Set Gateway Management IP Address, Set Gateway Management Subnet
Mask, and if required, Set Management Default Gateway Address and click the
Submit button.
Power On Self Test and IP Address Setup
and the software is operational, the
Cisco VG30D Voice Gateway Quick Start Guide
9