Factory Resetting The Spa8800; Configuring Static Ip Address Addressing - Cisco SPA8800 Configuring

© 2009 Cisco Systems, Inc. All rights reserved.
Configuring the Cisco SPA8800 IP Telephony Gateway in an Asterisk Environment
Figure 2: An example of deploying 2 SPA8800s in an Asterisk Environment

Factory Resetting the SPA8800

You should factory reset the SPA8800 so that you start from a known starting point.
f. Connect an analog phone to the SPA8800 PHONE 1 port
g. Go off-hook, ignore the fast-busy or silence
h. Dial **** [four asterisks or stars]
i. Dial 73738# when prompted
j. Press 1 to confirm reset
k. Hang up when prompted

Configuring Static IP Address Addressing

You must configure the SPA8800 with a static IP address because this address is defined in the
Asterisk Server's /etc/asterisk/sip.conf file.
l. Determine the SPA8800's Dynamically Assigned IP Address
i. Connect an analog phone to the SPA8800 PHONE 1 port
ii. Go off-hook, ignore the fast-busy or silence
iii. Dial **** [four asterisks or stars]
iv. Dial 110# when prompted
v. Document the IP address
vi. Hang up
Page 13 of 69