Connecting Your Cisco Spa 301 To The Network - Cisco SPA303 User Manual

Installing Your Phone
Installing Your Cisco SPA 301 IP Phone
STEP 1
STEP 2
STEP 1
STEP 2
STEP 3
STEP 4
Cisco Small Business IP Phone SPA 30X User Guide (SPCP)

Connecting Your Cisco SPA 301 to the Network

Figure 2 Cisco SPA 301 Phone Ethernet Connection
If you are using an Ethernet connection:
Insert one end of the Ethernet cable into the network port on the phone body
marked "WAN" (labeled 3 in
Insert the other end of the Ethernet cable into the appropriate device, such as a
network switch, on your network.
(Optional) Connecting Your Cisco SPA 301 to the Wireless Network
You can use the Cisco WBP54G Wireless-G Bridge for Phone Adapters to connect
the IP phone to a Wireless-G network instead of the wired local network. To
connect your phone to the Cisco WBP54G:
Configure the Cisco WBP54G using the Setup Wizard. See the instructions in the
Wireless-G Bridge for Phone Adapters Quick Installation Guide
cisco.com. See Appendix A, "Where to Go From Here,"
and locations.
During the Setup Wizard process, connect the Ethernet network cable of the
WBP54G to the back of the IP phone base station into the slot marked "WAN."
Connect the power cable of the WBP54G to the power port on the IP phone base.
Plug the IP phone power adapter into the power port of the WBP54G.
Figure 2).
2
, available on
for a list of documents
15