Philips HDRW720/69 Operating Instructions Manual page 81

PROBLEM SOLUTION
b
1
Clean the disc
Open the disc tray with OPEN/CLOSE J . Insert the disc but do not close the tray.
2
3
Hold down the red function button on the remote control until the tray closes. The disc is
prepared for erasing.
4
Start recording as with an empty disc.
b
1
Make sure that the surface of the disc is clean.
Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but
2
.
3
Hold down 5 on the remote control until the tray closes. The disc will be read ('
appears on the display) and the DVD recorder will start the repair process. This may take up
to four times as much time as the recording, in which the error occurred.
4
If the disc is recovered, the index screen will appear.
Please observe the following:
The recovering procedure is successfully only if there was a previous recording on the disc.
Error during recording: The title may be missing.
Error while changing the title/index picture: The original title/index picture may be visible.
Error while finalising: The disc appears not to have been finalised.
b
1 Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but
.
2
Hold down 4 on the remote control until the tray closes.
' ' appears in the display. Finalising begins. This may take up to three minutes.
3
If finalising has been successful, the index screen will appear.
b
1
First press DISC MENU then SYSTEM MENU .
2
Select the symbol '
3
Confirm the line '
control. The PIN code is reset to '0000'.
4
End with SYSTEM MENU
' using D , select '
(
' using C and pree 4 times STOP h on the remote
)' using B and confirm with C .
'