Philips HDRW720/69 Operating Instructions Manual page 20

To receive TV programmes you have to connect the DVD-recorder to
the aerial or the cable network.
1 Switch off your TV set.
2 Remove the aerial cable plug from your TV set. Insert it into the
ANTENNA IN socket at the back of the DVD recorder.
3 Insert one end of the supplied aerial cable into the TV
OUT socket at the back of the DVD recorder and the other end
into the aerial input socket at the back of the TV set.
The aerial input socket of the TV set may be labeled ANT IN, RF
IN, 75 ohm, etc. Check your TV instructions for details.
Choose from the following connections:
This connecting cable, also known as the SVHS cable, is used to
transmit the brightness signal (Y signal) and colour signal (C signal)
separately. This mini DIN socket/plug is also called a Hosiden
socket/plug.
1 Insert one end of an S-Video(SVHS) cable into the S-VIDEO
OUT (Y/C) socket at the back of the DVD recorder and the other
end into the S-Video (SVHS) input socket on the TV set (usually
labelled 'S-Video in' or 'SVHS in'. See TV operating instructions).
2 Insert one end of an audio (Cinch) cable into the red/white Cinch
socket AUDIO OUT L/R at the back of the DVD recorder and
the other end into the audio input socket (usually red/white) on
the TV set (usually labelled 'Audio in' or 'AV in'. See TV operating
instructions).
Read the next chapter 'Connecting additional devices' on how
to connect additional devices (satellite receivers,
videorecorders,...) to the input-/output sockets.
Then, read the chapter on 'Connecting to the mains'.