Philips HDRW720/69 Operating Instructions Manual page 37

G-code dvd recorder/hard disc

Hide thumbs Also See for HDRW720/69:

Use 'Programming a recording (TIMER)', to automatically start and stop

a recording at a later date.

The DVD recorder will switch to the right programme number and

begin recording at the correct time.

On this DVD recorder you can pre-programme up to 12 recordings

within a period of one month.

To make a programmed recording, your DVD recorder needs to

know:

* the date you want to make the recording

* the programme number of the TV channel

* the start and stop time of the recording

This information is saved in a 'TIMER block'.

Before you begin, make sure the clock is set. If the clock is not set, the

' menu will appear when you press the TIMER s button.

Thanks to this programming system, you no longer need to tediously

enter the date, programme number, start and finish times. All the

information needed by the DVD recorder for programming is

contained in the G-Code

programming number. This 9-digit G-Code

number is found in most TV listings magazine.

1 Switch on the TV set. If required, select the programme number

for the DVD recorder.

2 Press TIMER s on the remote control.

The '

' screen will appear

3 Press the red function button ('

4 Enter the entire G-Code number. This number is up to 9 digits

long and can be found next to the start time of the TV programme

in your TV listings magazine.

e.g.: 5-312-4 or 5,312 4

Enter 53124 for the G-Code-number.

Use therefore the number buttons 0..9 on the remote control.

If you make a mistake you can press D or the green action button

to go back a position.

5 Confirm with OK .

').