Philips HDRW720/69 Operating Instructions Manual page 29

a
b
D C
9 Check the displayed settings and confirm with OK .
P
' ' will appear briefly on the screen.
0 To end, press SYSTEM MENU .
Component video (Y Pb Pr) is the highest quality picture transmission
option. This is achieved by dividing the video signal into a luminance
signal (Y) and two colour difference signals - red minus luminance (V)
and blue minus luminance (U). As a rule, "Cr, Pr" or "R-Y" is used to
describe the red difference signal and "Cb, Pb" or "B-Y" the blue
difference signal.
These signals are transmitted through separate lines. The connectors of
this cable and the corresponding sockets are usually green (luminance,
Y), blue (U, Pb, Cb, B-Y), and red (V, Pr, Cr, R-Y).
If you choose this type of connection, the DVD recorder must already
be connected and completely installed (initial installation complete).
Switching of the signal to the COMPONENT VIDEO OUT sockets is
carried out in a menu that is not yet available during the initial
installation.
•) Switch on the TV set, and if necessary, select the programme number for the
DVD recorder.
•) Switch on the DVD recorder.
1 Press the DISC MENU and then the SYSTEM MENU button
on the remote control.
P
The menu bar appears.
2 Select '
' symbol with D or C .
3 Select the '
' symbol using B or A and confirm with C .
4 Select the line '
C .
5 Select your setting with B or A . If the YPbPr output (YUV
signal) is switched on, S-video (Y/C) and video (FBAS/CVBS) signals
will not be transmitted simultaneously.
Component Video (YUV) and S-Video(Y/C).
Timer menus only available on YUV ouput sockets.
Component Video (YUV) and Video (FBAS/CVBS).
Timer menus only available on YUV ouput sockets.
ï
' using A or B and confirm with