Advertisement
Available languages
Available languages
Digital output switched off.
For devices
You can select one of the following settings for devices that are
connected to the analogue audio output ( AUDIO OUT L/R ):
For devices without DolbySurround or TruSurround. Use this
setting if the DVD recorder is only connected to a stereo TV
set.
Dolby Digital and MPEG-2 multi-channel are mixed down to a
Dolby Surround-compatible two-channel output signal.
For devices
Night mode optimises the sound for playback at low volume. You are
therefore less likely to disturb your neighbours. This only works with
Dolby Digital audio on DVD video discs.
You can select the following settings in this menu:
Playback audio language.
Wahl der Audio-Aufnahme bei zweisprachigen Sendungen
Subtitle language
Screen menu language
Selection of the location
.
You can select the following functions in this menu:
.
Along with the on-screen menus, the OSD (On Screen Display) also
displays information on the current operating status (counter, playback,
recording, TV channel, ...) on the TV screen.
You can switch off the information about the operating status so that
the on-screen display is not recorded when making recordings on
additional devices.
With this function you can switch between the live picture or the
information of the selected TV channel/input socket in the 'Tuner
information box' (left-hand corner of the screen).
The live picture of the selected TV channel or signal on the input
sockets is visible.
If you haven't used the DVD-recorder for a few minutes in certain
modes (e.g.: STOP), it will switch to standby automatically. You can
cancel this function to use the DVD-recorder as a television receiver.
You can switch off the clock display on your DVD recorder to save
energy. Programmed recordings will be carried out despite of this.
In addition, you can have the most important features of your DVD
recorder appear in scrolling text in the display (demo).
The OSD information appears for a few seconds in each
selected mode and then disappears.
The OSD information is switched off. It is
displayed on the screen.
The information about the selected TV channel or signal on
the input sockets is visible.
The DVD-Recorder leave switched on.
The DVD-Recorder will be switched to standby after few
minutes.
Advertisement
