Advertisement
Available languages
Available languages
This section describes how you can make additional personal settings.
The symbols have the following meaning:
•) Switch on the TV set, and if necessary, select the programme
number for the DVD recorder.
•) Switch on the DVD recorder.
1 Press the SYSTEM MENU button on the remote control.
P
The menu bar appears.
2 Select '
' using D oder C and confirm with
3 Select the corresponding function using B or A and confirm
with C .
4 Select the corresponding line using B or A and confirm with
C . For more information on each function, read the following
pages.
5 Select the corresponding function using B or A , or the setting
with D or C . Select the functions you want to change as
described in the following pages.
6 Confirm the new setting with OK .
7 Close the menu item with D .
In this menu you can adapt the picture from the DVD-Recorder to
your TV set.
Additionally you can adjust the Colour, the Brightness, the Contrast,
for playback from the internal tuner or input sockets seperately You
can select the following functions in this menu:
The picture signal from your DVD recorder can be set to match your
TV set:
for a widescreen picture with black bars at the top and
bottom
'
'
for a full-height picture with the sides trimmed.
'
'
for a widescreen TV set (16:9 screen ratio)
Use this feature to adjust the position of the picture on your TV left or
right using D , C to suit the screen of your TV set.
Since RGB and S-VIDEO signals sometimes use the same connections
on a scart cable, the two signals cannot be transmitted simultaneously.
With these settings, you can decide whether RGB or S-VIDEO signals
are to be transmitted. This setting affects only the scart sockets of the
DVD recorder ('
TV-I/O and '
Please also observe which signals are available at which scart socket of
the TV set or how the scart sockets need to be switched.
If necessary, consult the instruction manual of your TV set.
Depending on the TV set you are using, switching between the
'RGB' and the 'Video(CVBS/FBAS)' signal is done automatically.
ï
': Output socket EXT1 TO
': Input socket EXT2 AUX-I/O )
Advertisement
