Advertisement
Available languages
Available languages
Do not confuse these sockets with the five-component RGB
sockets (if available) or the yellow video (CVBS/FBAS) socket and
the two audio sockets (red/white). The five-component RGB
sockets are only provided for the R-G-B-H-V signals (red, green,
blue with horizontal and vertical synchronisation impulse).
8 Use an audio (cinch) cable, connect the red/white cinch socket
AUDIO OUT L/R at the back of the DVD recorder with the
most coloured red/white audio input socket of your TV set
(usually labelled 'Audio in' or 'AV in'. See the instruction manual of
your TV set.)
9 If necessary, switch the TV set to the component video
(Progressive Scan) input sockets. If there is a switch or selection
on your TV-set between 'Interlaced' and 'Progressive scan' select
'Progressive scan'.
You may need to refer to your TV operating instructions.
P
The menu of the DVD recorder should now appear on the TV
screen. If not, check the cable connections and the settings on
your TV set.
If necessary store this setting on your TV set.
0 End with SYSTEM MENU .
In some cases, not all of the available TV channels may have been found
and stored during initial installation. In this case, you will need to search
for and store the missing or coded TV channels manually.
•) Switch on the TV set, and if necessary, select the programme
number for the DVD recorder.
•) Switch on the DVD recorder.
1 Press the SYSTEM MENU button on the remote control.
P
The menu bar appears.
2 Select '
' symbol with D or C .
3 Select '
' using B or A and confirm with C .
4 Select '
' using B or A and confirm with C .
5 In '
', select the desired display using C .
(Frequency),
(Channel),
channel)
6 In '
', enter the frequency or channel of the TV
station using the number buttons 0..9 .
Press C in the line '
search.
P
A changing channel number/frequency number will appear on
the TV screen.
Continue the automatic search until you have found the TV
channel you are looking for.
7 Using D or C in '
number you want to use for the TV channel, e.g. '
8 Press OK to store the TV channel.
9 To search for other TV channels, begin again at
- In '
- Select the desired character position using D or C .
- hange the character at the desired position with B or A .
- Select the next character position in the same way.
- Confirm with OK .
', use D or C to select the TV system that
- In '
produces the least distortion of picture and sound.
- If reception is poor and the sound distorted you can turn off
NICAM.
In '
', select '
- You can try fine tune the TV channel manually with D ,
C in the line '
0 To end, press SYSTEM MENU .
(Special/hyperband
' to start the automatic
', select the programme
'.
6
.
', press C .
' using C .
'.
Advertisement
