Advertisement
Available languages
Available languages
Use 'Programming a recording (TIMER)', to automatically start and stop
a recording at a later date.
The DVD recorder will switch to the right programme number and
begin recording at the correct time.
With this DVD recorder, you can pre-programme up to six recordings
within a period of one month.
To make a programmed recording, your DVD recorder needs to
know:
* the date you want to make the recording
* the programme number of the TV channel
* the start and stop time of the recording
* VPS or PDC on or off
* the recording mode (picture quality) ('
This information is saved in a 'TIMER block'.
Before you begin, make sure the clock is set. If the clock is not set, the
' menu will appear when you press the TIMER s button.
'
/
/
/
/
/
/
')
Thanks to this programming system, you no longer need to tediously
enter the date, programme number, start and finish times. All the
information needed by the DVD recorder for programming is
contained in the ShowView
®
programming number. This 9-digit
ShowView
®
number is found in most TV listings magazine.
1 Switch on the TV set. If required, select the programme number
for the DVD recorder.
2 Press TIMER s on the remote control.
The programming method selected last is marked.
3 Select '
C .
4 Enter the entire ShowView number. This number is up to 9 digits
long and can be found next to the start time of the TV programme
in your TV listings magazine.
e.g.: 5-312-4 or 5,312 4
Enter 53124 for the ShowView-number.
If you make a mistake, you can clear your instructions with
CLEAR .
SELECT
5 Confirm with OK .
' using B or A and confirm with
Advertisement
