Kenwood XD-981MD Instruction Manual page 82

82
CD player section
Symptom
A CD is placed in the player but it cannot
be played.
Sound is not produced.
Sound skips.
CD player section (in regard to message display)
Displayed Message
Err** (** indicates a number)
Remote control unit
Symptom
Remote control operation is not possible.
Cause
÷ The disc is placed upside down.
÷ The disc position is displaced.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ Dew is condensed on the optics lens.
÷ The disc has not been placed.
÷ The player is not put to the play mode.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ The disc is dirty.
÷ The disc is scratched.
÷ The player is subject to vibration.
Meaning
÷ This indicates some trouble. The number
differs according to the trouble contents.
Cause
÷ Batteries are exhausted.
÷ The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
÷ There is no CD or MD set in the component
to be played.
Remedy
÷ Place the disc properly, with the label side
facing upward.
÷ Place the disc properly.
÷ Clean the disc referring to "Disc handling
precautions".
÷ Try another disc.
÷ Refer to "Caution on condensation" and
remove the condensation by evaporation.
÷ Place a disc in the CD player.
÷ Press the 6 key.
÷ Clean the disc referring to "Disc handling
precautions".
÷ Try another disc.
÷ Clean the disc referring to "Disc handling
precautions".
÷ Try another disc.
÷ Install the unit in a place not subject to
vibrations.
Action
÷ Return to normal condition is made by
switching the unit off and then on again.
Remedy
÷ Replace with new batteries.
÷ Operate the unit inside the remote control-
lable range.
÷ Set a CD or MD in the component to be
played.
In case of difficulty
XD-981MD (En)
5
j
5
5
$
$