Operation Of Remote Control Unit; Channel Space Setting - Kenwood XD-981MD Instruction Manual

Operation of remote control unit

14
Loading batteries
1 Remove the cover.
Operation
After plugging the power cord of this unit, press the ON/
) key of the remote control unit to turn the
STANDBY (
system ON. When the system is turned ON, press the key
of the function to be operated.
Press the ON/STANDBY (
time display will remain lit and standby status will be
reached.
÷ When pressing more than one remote control keys successively,
press the keys securely by leaving an interval of 1 second or more
between keys.
1. The provided batteries are intended for use in operation checking, and their service life may be short.
2. When the remote controllable distance becomes short, replace both of the batteries with new ones.
Notes Notes
3. If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote sensor, malfunction may occur.
In such a case, change the installation position to avoid malfunction.

CHANNEL SPACE setting

(Except for U.S.A., Canada, U.K., Europe, Australia and Russia)
The CHANNEL SPACE setting is set to the correct setting that
prevails in the area to which the unit is shipped.
However, if the CHANNEL SPACE setting is not matched to the
area where the unit is to be used; for instance, when you move
from area 1 to area 2 or vice versa, desired reception of AM/FM
broadcasts is not expected. In this case, change the CHANNEL
SPACE setting in accordance with the area corresponding to the
table.
Area
U.S.A., Canada,
1
South American countries
Other countries
2
2 Insert batteries.
÷ Insert two R6 ("AA"-size) batteries following the polarity indications.
) key again for OFF. Only the
CHANNEL
SPACE freq.
and FM: 100kHz
AM: 10kHz
FM: 50kHz
AM: 9kHz
3 Close the cover.
2
Remote sensor
6m
Operating range (approx.)
1 Switch off the unit.
2 Select the channel space
Switching is done each time the key is pressed.
1 "CH SPACE"
......... FM: 100 kHz steps,
2 "CH SPACE"
......... FM:
EDIT
TITLE SEARCH
C H N S P A C E
÷ There is no display for the AM part, but the step is switched
simultaneously with the FM switching.
3 Confirm
Controls and indicators
XD-981MD (En)
2
¶ 0
30˚ 30˚
ON/STANDBY
(AM: 10 kHz)
50 kHz steps,
(AM: 9 kHz)
STEREO TUNED
DIGITAL TOTAL
F M 1 0 0
9
kHz