Kenwood XD-981MD Instruction Manual page 32

32
How to use the REC INPUT SELECT key
Digital recording is executed automatically when the
input selection is CD. For analog recording from a CD, use
the REC INPUT SELECT key.
Each press switches the modes as follows.
1 "DIGITAL" is lit : Digital recording
2 Not lit
TITLE SEARCH
C D 1 D I S C
At the time of recording from a CD, the track number may be incremented when CD playback starts. This occurs because of a signal included
Note Note
in the digital signal from the CD. Delete unwanted track numbers under reference to "TRACK ERASE or ALL ERASE".
REC INPUT
SELECT
: Analog recording
"DIGITAL" goes off
STEREO
DIGITAL
0 0 1 0 0 0 0 0
: 2 4
:
.
In regard to track numbers at the time of recording
When a part without sound continues for 2 sec. or more during
recording, the track number is automatically increased by "1"
when the next sound enters. When classic music continues with
low sound, the track number may be increased by "1". The er-
roneously set track number can be erased later.
When it is desired to increase the track No. during recording,
press the TRACK EDIT key during recording to record a track
No. at that position.
The track numbers are used at the time of playback to find the
start of tracks, for programming, etc.
TUNED
TOTAL
÷ With digital recording from a CD, the track number is increased when
the track changes. (The track number is not increased even when there
is a part without sound in excess of 2 sec in the track.)
Let's put out some sound Let's recording
XD-981MD (En)
Press during recording.
TRACK EDIT
Á