Various Cd Playback Features; Listening To The Desired Sequence (Program Playback) - Kenwood HM-636 Instruction Manual

Various CD playback features

Listening to the desired sequence
Use the following procedure to program desired tracks in a desired order. (up to 32 tracks)
Select the CD input.
1
Select "PGM" mode.
Press in stop mode
PGM
2
Select track numbers in the order you want to play them.
1
Select the track.
1 2
4 5
7 8
10 0
2
(Go to step within 20 seconds.)
2
Confirm the selection.
SET
(To select more than one track, repeat steps 1 and
2 for each track.)
3
Start playback.
CD
3
6
9
6
(program playback)
Press the numeric keys as shown below....
To select track No. 23 : +10
To select track No. 40 : +10
÷ Up to 32 tracks can be programed. When "PGM FULL" is
displayed, no more tracks can be programed.
÷ If you made a mistake, press the CLEAR key and enter
the track No. again.
÷ When a track No. is entered, the track will be added to
the end of the existing program.
÷ When the total time of CD program is 200 minutes or
more, the time display shows " - - : - - ".
÷ Tracks will be played in the order they were pro-
gramed (following the program numbers).
÷ When the 4 key is pressed once during playback,
the track being played will be played from the
begining.
To skip further to a track preceeding the current track,
press the 4 key twice repeatedly.
÷ When the ¢ key is pressed during playback, play will
skip to the next track in the program.
Various CD playback features
Program position of the track
to be selected next.
Selection of tracks
2, 3
X
4, 0
X
29
EN