Various Cd Playback Features; Listening To The Desired Sequence (Program Playback) - Kenwood R-K701 Instruction Manual

Various CD playback features

Listening to the desired sequence
Use the following procedure to program desired tracks in a desired order. (up to 32 tracks)
Select the CD input.
1
Select PGM mode.
Press the P.MODE key on the remote control
unit.
Press the key in
the stop mode.
2
Select track numbers in the order you want to play them.
1
Select the track number with the Numeric
keys on the remote control unit.
2
(Go to step within 20 seconds.)
2 Press the ENTER key to confirm the
selection.
(To select more than one track, repeat steps 1 and
2 for each track.)
3
Start playback.
Press the CD 6 key.
(program playback)
CD
PGM
The indicator lights up.
CD
PGM
Press the Numeric keys as shown below;
To select track No. 23: +10, +10, 3
To select track No. 30: +10, +10, +10, 0
÷ Up to 32 tracks can be programmed. When "PGM
FULL" is displayed, no more tracks can be
programmed.
÷ If you made a mistake, press the CLEAR key and enter
the track No. again.
÷ When a track No. is entered, the track will be added to
the end of the existing program.
÷ When the total time of CD program is 1000 minutes or
more, the time display shows "- - - : - -".
÷ Tracks will be played in the order they were
programmed (following the program numbers).
÷ When the 4 key is pressed once during playback, the
track being played will be played from the beginning.
To skip further to a track proceeding the current track,
press the 4 key twice repeatedly.
÷ When the ¢ key is pressed during playback, play will
skip to the next track in the program.
1 2 3 4 5
L
TTL
30 10 5 3 1 0 (-dB)
R
1 2 3 4 5
L
TTL
30 10 5 3 1 0 (-dB)
R
33
EN