Kenwood HM-636 Instruction Manual page 19

To wind tape at high speed
To fast wind in
direction |
1
TUNING
÷ Press the STOP 7 key to stop fast winding.
÷ The same operation is also available with the 4
and ¢ keys on the main unit.
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Lit when "TAPE EQ." is ON
TAPE EQ.
Each press switches the modes as follows.
1 "TAPE EQ." ON
TAPE equalizer is used)
(
2 "TAPE EQ." OFF
TAPE equalizer is not used
(
÷ Select the "TAPE EQ." ON mode according to the
recording condition of the tape.
To stop playback
STOP 7
To fast wind in
direction \
1
)
AUTO/MONO
Selection of reverse mode
Main unit only
1
Select "TAPE RVS".
\
\
2
Select.
1 " " : (ONE-WAY)
Only one side is played back (recorded), and
then the tape stops.
2 "
" : (REVERSE)
Both sides are played back (recorded), and
then the tape stops. When the tape transport
direction is "2", the tape stops after one side
has been played (recorded).)
3 "
" : (ENDLESS)
Both sides are played back endlessly. (The
tape stops after recording onto both sides.
When the tape transport direction is "2", the
tape stops after one side has been recorded.)
(The initial setting is "
3
Set it.
A tip for use of the tape counter
The tape counter is set to "0000" when a cassette
tape is loaded. By writing down the counter read-
ing in case you want to interrupt recording (play-
back) in the middle of the tape, the memo will be
helpful as a reference for locating the same posi-
tion when continuing the recording (playback) the
next time. The tape counter figure decreases dur-
ing recording or playback of the back side (while
the 2 tape transport indicator is lit). To set the tape
counter to "0000", open the cassette holder once.
Then the counter will be reset.
Playback of TAPE
\
\
"(REVERSE))
19
EN