Auto Connection - AT&T TL92270 User Manual

Bluetooth
Bluetooth setup
9. When the handset displays Headset A paired to base.
Connect now? Press SELECT, then press
on the handset.
• When you already have two devices on the active
devices list, the handset shows Maximum of 2
devices can be connected. You are prompted to
replace an existing headset on the active devices list
(page 21).
• When you already have one headset on the active
devices list, the handset shows Only 1 headset can
be connected. You are prompted to replace the
headset on the active devices list (page 21).
10. Headset setup completed Device connected and the corresponding
status icon (
The corresponding light on the telephone base (DEVICE1 or DEVICE2)
turns on.
NOTES:
1. The pairing process may take up to one minute. If the pairing process fails, try again.
2. If you put the handset back in the telephone base or charger while pairing, the process
discontinues and the handset returns to idle mode.

Auto connection

When a device is successfully paired with the telephone
base but not connected, the handset displays Headset setup
completed Device not connected and then
Auto-connect function enabled Press SELECT. You can
press /SELECT to exit. You can also connect a device
MENU
manually (page 20).
1 or 2) display when a device is successfully connected.
/SELECT
MENU
17
Headset A
paired to base.
Connect now?
Press SELECT
Headset setup
completed
Device
connected
Headset setup
completed
Device not
connected
Auto-connect
function
enabled
Press SELECT