Handset settings
Answering system settings
Remote access code
A two-digit security code is required to access the answering system
remotely from any touch-tone telephone. The preset code is 19. You can
change the code to any number from 00 to 99.
To change the remote code:
1.
Press MENU/
the main menu.
2.
Use
CID
or DIR to scroll to Answering sys, then press
/SELECT.
MENU
CID
or DIR to scroll to Ans sys setup, then press
3.
Use
/SELECT.
MENU
CID
or DIR to scroll to Remote code, then press
4.
Press
/SELECT.
MENU
5.
Use the dialing keys (0-9) to enter a two-digit number
from 00-99, then press
•
Press
MUTE
•
Press and hold
•
Press
CID
6.
Press
/SELECT to confirm your setting. You hear a confirmation tone.
MENU
Message alert tone
When the message alert tone is set to On, the telephone base beeps every
10 seconds to alert you of new messages. The tone stops when all new
messages have been reviewed. The default message alert setting is off.
To set the remote access code:
Press MENU/
1.
the main menu.
CID
or DIR to scroll to Answering sys, then press
2.
Use
/SELECT.
MENU
3.
Use
CID
or DIR to scroll to Ans sys setup, then press
/SELECT.
MENU
4.
Press
CID
or DIR to scroll to Msg alert tone, then
press
/SELECT.
MENU
5.
Press
CID
or DIR to choose between On and Off.
6.
Press
/SELECT to confirm your setting. You hear a confirmation tone.
MENU
on the handset in idle mode to enter
SELECT
MENU
/DELETE to erase a digit.
/DELETE to erase all digits.
MUTE
to move the cursor to the left or DIR to the right.
on the handset in idle mode to enter
SELECT
/SELECT to confirm.
38
ANS SYS SETUP
Cal l screening
# of rings
Remote code
Msg alert tone
REMOTE CODE
19
ANS SYS SETUP
Cal l screening
# of rings
Remote code
Msg alert tone
MSG ALERT TONE
On
Off