Cable Connections
AC Voltage Check
AC Voltage Check
This section provides voltage check information for use on the customer site. The emphasis focuses on
measuring the voltages at the power cord plug end specified as an IEC 320 C19 type plug. This end plugs
directly into the back of the HP Integrity rx7620 Server chassis.
NOTE
These procedures must be performed for each power cord that will be plugged directly into the
back of the HP Integrity rx7620 Server. If the expected results from this procedure are not
observed during the voltage check, refer to the next section titled "Voltage Check (Additional
Procedure)."
72
Chapter 4