Figure 3-12 Hold-Down Plate And Screw - HP Integrity rx7620 Installation Manual

Installing Additional Components
DVD+RW Installation Instructions
Step 6. Loosen the screw on the hold-down plate to adjust the length of the cable.

Figure 3-12 Hold-down plate and screw

Step 7. Slide the hold-down plate toward the rear of the chassis until the tabs disengage. Do not move the
plate further than necessary to disengage the tabs.
Step 8. Adjust the length of the SCSI and power cables to the appropriate service length described in Step
3.
Step 9. Pull any excess cable length into the main chassis, and store it between the MSBP and the SCSI
Ferrite.
Step 10. Replace the hold-down plate by pushing down, while sliding it toward the front of the chassis.
Step 11. Engage the tabs into the slots. Verify that all the tabs are captured in their slots.
Step 12. Remove the DVD+RW drive from package.
Step 13. Install the side rails onto the drive.
Step 14. Connect the removable media bay power cable to the loose end of the Y power cable on the
DVD+RW assembly. Ensure that the mating connector pair passes through the ruggedizer.
Step 15. Route the removable media bay power cable into the ruggedizer cable clip.
64
Plate
Screw
Hold Down
Plate
Chapter 3