Unpacking the Server
Unpacking a Non-Racked Server
Unpacking a Non-Racked Server
NOTE
If this server was delivered with a wheel kit, proceed to Chapter 2, Installing Additional
Components.
HP recommends the use of a lifter, such as a RONI Company model 17000 SP 400 lifting
NOTE
device, when moving a non-racked system, shown in Figure 2-5. If no lifter is available, install
the lift handle panels provided with the system.
Unloading with a Lifter
Use the following procedure to unload the server from the pallet using a lifter.
Use caution when using a lifter. Because of the weight of the server, it must be
WARNING
centered on the lifter forks before raising it off the pallet to avoid injury.
Never extend more than one server from the same cabinet while installing or
servicing another server product. Failure to follow these instructions could result in
the cabinet tipping over.
36
Chapter 2