Figure 2-11 Lift Handles Mounted - HP Integrity rx7620 Installation Manual

Unpacking the Server
Unpacking a Non-Racked Server
5. Pull the string plunger out, move the handles apart, and install the shoulder washer end of the panel into
the keyway feature.
Figure 2-11 Lift Handles Mounted
6. Continue to pull the handles apart until the spring plunger snaps into final position. The spring plunger
will drop down into the recess position.
7. Ensure that the handles are secure by pressing the handles together and moving back and forth.
8. Repeat steps above for the other handle.
9. To lift the server, rotate the handles 90 degrees to horizontal position.
NOTE If installing the system in a rack, refer to the Installation Guide, HP J1530B,
Rack Installation Kit.
10. After moving the server, remove the lift handle panels from the chassis and reinstall the server covers
and front bezel. Refer to the Installation Guide, HP J1530B Rack Installation Kit.
42
Chapter 2