7.1
[System Settings]
Factory default
[Changing the "From" Ad-
dress]
[Change Registered Over-
lay] *
[Biometric/IC Card Infor-
mation Registration] *
[Restrict Broadcasting]
* This item is displayed only when a Hard Disk is installed.
7.1.7
[Expert Adjustment]
Make adjustments so that output quality is increased.
%
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment].
Settings
[AE Level Adjustment]
[Printer Adjustment]
bizhub 423/363/283/223
[Login User Address]
[Allow]
[Restrict]
[No]
Configure the initial value for AE (auto exposure). The higher the setting,
the more that the original background is emphasized.
Adjust the starting print position and defective print images caused by pa-
per type features.
d
Reference
The starting print position is factory-adjusted. Normally, you
are not required to change the set values.
[Leading Edge Adjustment]
[Centering]
[Leading Edge Adjustment (Du-
plex Side 2)]
[Centering (Duplex 2nd Side)]
[Erase Leading Edge]
[Vertical Adjustment]
[Media Adjustment]
p. 7-11
p. 7-11
p. 7-11
p. 7-11
Adjust leading edge erase width.
For details on displaying this item,
contact your service representative.
Adjust the feed direction zoom ratio of
paper types.
For details on displaying this item,
contact your service representative.
p. 7-12
7
7-8