Power Save - Konica Minolta bizhub 223 User Manual

4.6

Power Save

4.6 Power Save
If no operation is performed for a specified length of time, the touch panel goes off and the machine auto-
matically enters a mode where it conserves energy. This is referred to as Low Power or Sleep mode.
The following describes the procedure for returning from Low Power or Sleep mode.
0 Although the machine conserves more energy in Sleep mode than in Low Power mode, the warm-up
process for returning to ready-for-copy state from Sleep mode is more time-consuming.
0 As the factory default, Low Power mode is set to restart after 15 minutes and Sleep mode after 20 min-
utes. In other words, the machine enters Low Power mode if no operation is performed for 15 minutes.
Likewise, it enters Sleep mode after 20 minutes has elapsed.
0 The machine can receive jobs even while it is in Low Power mode.
%
Press the Power Save key.
The machine returns from Low Power mode when any other key on the Control Panel or the Touch
Panel surface is pressed.
d
Reference
To enable Low Power mode:
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Power Save Settings].
bizhub 423/363/283/223
4
4-11