Konica Minolta bizhub 223 User Manual page 68

5.1 [Basic]
Settings
[Offset] [Yes]/[No]
[Fold/Bind]
[Staple]
[Punch]
[Position Setting]
bizhub 423/363/283/223
Specify whether to separate each set of copies from another set in the output
tray when copying multiple sets of multi-page originals.
When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is not
installed:
If the following conditions are met, printed copies are fed out and sorted in an
alternating crisscross pattern.
• The 8-1/2e11, A4, or B5 size paper is used
• Paper of the same size and type is loaded with the w orientation in one pa-
per tray and with the v orientation in another tray
• Auto paper selection is specified for the paper size setting
When the Finisher FS-527, Finisher FS-529, or Job Separator JS-505 is in-
stalled:
The copies are fed out and stacked on top of each other with each set shifted
to separate it.
Staples copy outputs in the center the paper or fold them in the center before
discharging.
[Half-Fold]
Staples copies in corner or at two points before they are output.
Punches holes in copies before they are output.
1
Configure desired staple or hole-punch positions.
Select Auto, and the machine automatically judges the staple or punch posi-
tions for the paper relative to the original direction loaded.
• A staple or punch position along the long side of the paper is selected if the
original length is 11-11/16 inches (297 mm) or less.
• A staple or punch position along the short side of the paper is selected if
the original length exceeds 11-11/16 inches (297 mm).
• Staple or punching positions are set on the upper or left-side end.
• Be sure to load the original so that its top side is placed in the back.
• If desired, press [Original Direction], and then select the original direction.
[Center Staple & Fold]
5
5-12