Konica Minolta bizhub 223 User Manual page 142

7.1 [System Settings]
Settings
[Erase Adjustment]
[Maximum Density Adjust-
ment]
[Drum Dry]
[Replenish Toner]
Factory default
[AE Level Adjustment]
[Leading Edge Adjustment]
[Centering]
[Leading Edge Adjustment
(Duplex Side 2)]
[Centering (Duplex 2nd
Side)]
[Media Adjustment]
[Center Staple Position]
[Half-Fold Position]
[Punch Horizontal Position
Adjustment]
[Punch Regist Loop Size
Adjustment]
[Paper Separation Adjust-
ment]
[Prior Detection Setting]
[Feed Cleaning Settings]
[Non-Image Area Erase
Operation Settings]
bizhub 423/363/283/223
[Non-Image Area Erase Opera-
tion Settings]
This function is useful when the required printing result is not obtained, for
example, the printing density is too high or too low.
Adjust the amount of toner that is to be adhered to the paper based on the
printing density value set to the highest level in order to fine-adjust the en-
tire printing density setting (amount of toner).
If the required printing density result is not obtained after the maximum
density has been adjusted, contact your service representative.
Press [Dark] or [Light] to adjust the printing density.
If the room temperature changes rapidly or the humidity is high, dew may
form around the photo conductor in this machine, causing smudgy images
to be generated. In this case, using this function removes dew condensa-
tion from around the photo conductor.
Press Start to start drum dry processing.
Directly after replacing the toner bottle or after printing a large number of
originals with many black areas, the machine cannot sufficiently replenish
the toner, and printing density may fall temporarily. In this case, using this
function forcibly replenishes the toner.
Press Start to start replenishing toner.
Standard (2)
0.0 mm
0.0 mm
0.0 mm
0.0 mm
[Auto]
0.0 mm
0.0 mm
0
0
0.0 mm
[Yes]
[Warning Display]: [TYPE1]
[Detection level]: [Std.]
[Clean]
[Erase Operation]: [Specify]
[Erase Method]: [Rectangular]
[Original Density]: [1]
Configure Non-Image Area operation
settings.
[Auto]:
Automatically detects the background
density of the original, and selects ei-
ther [Bevel] or [Rectangular] accord-
ingly.
[Specify]:
Allows you to manually specify an
erase method and original density. As
an erase method, select [Bevel] or
[Rectangular]. Specify an original den-
sity from five levels.
7
7-10