How To Enable And Disable A Radius Server; How To Delete A Radius Server From The Configuration; How To Change A Radius Server Configuration; How To Change The Order In Which Radius Servers Are Contacted For Service - HP AA979A - StorageWorks SAN Switch 2/8V Administrator's Manual

How to enable and disable a RADIUS server

1. Connect to the switch and log in as admin.
2. Enter this command to enable RADIUS + local:
switch:admin> aaaconfig --radiuslocal
Local is used if the user authentication fails on the RADIUS server. Or to enable RADIUS + localbackup:
switch:admin> aaaconfig --radiuslocalbackup
.Local is used if the RADIUS servers are not accessible.

How to delete a RADIUS server from the configuration

1. Connect to the switch and log in as admin.
2. Enter this command:
switch:admin> aaaConfig --remove
server
3. At the prompt, enter y to complete the command.
When the command succeeds, the event log indicates that the server is removed.

How to change a RADIUS server configuration

1. Connect to the switch and log in as admin.
2. Enter this command:
switch:admin> aaaConfig --change
| chap]
server
-p port
-s secret
-t timeout Optionally, enter the length of time (in seconds) the server has to respond
-a[pap|cha
p]

How to change the order in which RADIUS servers are contacted for service

1. Connect to the switch and log in as admin.
2. Enter this command:
switch:admin> aaaConfig --move
server
to_positio
n
When the command succeeds, the event log indicates that a server configuration is changed.
76 Managing user accounts
server
Servers are listed by either name or IP address. Enter either the name or IP
address of the server to be removed.
server
Servers are listed by either name or IP address. Enter either the name or IP
address of the server to be changed.
Optionally, enter a server port.
Optionally, enter a shared secret.
before the next server is contacted.
Specify PAP or CHAP as authentication protocol.
server to_position
Servers are listed by either name or IP address. Enter either the name or IP
address of the server whose position is to be changed.
Enter the position number to which the server is to be moved.
| all
port secret
[-p ] [-s ] [-t
timeout
] [-a pap