HP AA979A - StorageWorks SAN Switch 2/8V Administrator's Manual page 174

Disable the strict fabric-wide policy using the fddCfg --fabWideSet ""command. The "absent"
•
setting disables the fabric-wide consistency policy.
Retry the firmware download operation.
Message
The switch is currently configured with "radiuslocal" mode. Please use the
it before proceeding.
Probable Cause and Recommended Action
The firmware download operation was attempting to downgrade a system to Fabric OS v5.1.0 or lower
and radiuslocal mode is enabled. The radiuslocal mode is not supported on firmware v5.1.0 or lower, so
the firmware download operation failed.
Disable the radiuslocal mode using the aaaConfig -localOnly command. Retry the
firmwareDownload operation.
Message
The command failed due to DHCP is enabled. Please use the
proceeding.
Probable Cause and Recommended Action
The firmwareDownload operation was attempting to downgrade a system to Fabric OS v5.1.0 or lower
and the DHCP feature is enabled. The DHCP feature is not supported on firmware v5.1.0 or lower, so the
firmwareDownload operation failed.
Disable the DHCP feature using the ipAddrSet command. Retry the firmware download operation.
Message
Cannot downgrade directly to version 4.4 or lower. Please downgrade to 5.1 or 5.0 first and then download
the desired version.
Probable Cause and Recommended Action
The firmware download operation was attempting to downgrade a system directly to Fabric OS v4.4.0 or
lower. This firmware jump is not supported, so the firmware download operation aborted.
Downgrade the system to firmware v5.1.0 or 5.0.0 first, and then download to the desired firmware
version.
Message
The command failed due to network timeout.
Probable Cause and Recommended Action
The firmware download operation was attempting to upgrade the system from Fabric OS v4.4.0 or lower
directly to firmware v5.2.x. This firmware jump is not supported, so the firmware download operation
aborted.
Upgrade the system to firmware v5.1.0 or 5.0.0 first, and then download firmware v5.2.x.
Message
DCC policy contains more than 256 numbers of ports. Please use the
secpolicyactivate
Probable Cause and Recommended Action
The firmware download operation was attempting to downgrade the system to Fabric OS v5.1.0 or lower
and the number of ports in a DCC policy of the Active or Defined database is greater than 256. This DCC
policy is not supported on firmware v5.1.0 or lower, so the firmwareDownload operation aborted.
174 Installing and maintaining firmware
commands to remedy this.
aaaconfig
command to disable it before
ipaddrset
secpolicydelete
command to remedy
and