Configuring M-Series Or Mcdata For Interconnection; Efcm San Status - HP AA979A - StorageWorks SAN Switch 2/8V Administrator's Manual

For information about edge fabric setup on E_ports and interswitch linking, see
Trunking" on page 333. For information on EX_Port Frame trunking setup on the FCR switch, see
EX_Port Frame
1 1. Capture a SAN profile of the McDATA and HP SANs, identifying the number of devices in each SAN.
By projecting the total number of devices and switches expected in each fabric when the LSANs are
active, you can quickly determine the status of the SAN by issuing the commands nsAllShow and
fabricShow on the HP fabric.
The nsAllShow displays the global name server information and fabricShow displays the fabric
membership information. The following examples illustrate the use of these commands.
wta_switch:admin> fabricshow
Switch ID
-------------------------------------------------------------------------
1: fffc01 10:00:00:60:69:e4:00:36 10.33.13.91
"wtQA_saturn91"
218: fffcda 10:00:00:60:69:90:02:b3 10.33.13.218
>"SW3900_WT218"
You can use SAN Pilot or EFCM to gather similar information for the McDATA fabric.
Figure 12

EFCM SAN status

When you have configured the 400 MP Router and B-Series MP Router (FR4- 1 8i) blade to connect to a HP
fabric, you must create LSAN and zones for the SAN. Once you have set up LSAN zoning, you can issue
the cfgShow command to verify that the zoning is correct.
NOTE: The procedures related to McDATA that are described in this section were current when the
document was written, but may have changed since then. For the most up-to-date information, refer to the
McDATA documentation about zone configuration on McDATA fabrics.

Configuring M-Series or McDATA for interconnection

To ensure connectivity with the HP fabric, you must prepare the M-Series or McDATA fabric for use with the
400 MP Router and B-Series MP Router (FR4- 1 8i) blade.
NOTE: The procedures related to McDATA that are described in this section were current when the
document was written, but may have changed since then. For the most up-to-date information, refer to the
McDATA documentation about zone configuration on McDATA fabrics.
232 Using the FC-FC routing service
trunking" on page 223.
Worldwide Name Enet IP Addr FC IP Addr
220.220.220.91
10.10.10.11
"Administering ISL
"Using
Name