Yamaha MCX-C15 - MusicCAST Network Audio Player Install Manual page 30

Problem
The client does The volume setting of the
not output any client is low.
sound.
The speakers are not correctly
connected to the MCX-CA15.
The "Amplifier" menu settings
on the client are incorrect.
Playback from
The network is extremely
the client skips. congested.
The STATUS The cables are not connected
indicator on the
correctly.
front panel of
the MCX-CA15
flashes rapidly.
You are using low-impedance
speakers.
Cause
Increase the volume setting.
Check the connections between
the speakers and the MCX-CA15.
Make sure the name of the
receiver connected to the client is
set correctly in the "Amplifier"
menu.
Place your clients under an
independent subnet mask, or
upgrade your network hardware.
Connect the cables correctly.
When using the MCX-CA15 in
the MusicCAST system, press
to reset the system.
When using the MCX-CA15 as
an amplifier for another system,
press RESET on the inside front
panel of the MCX-CA15 to reset
this unit.
Use speakers with an impedance
of at least 4
When using the MCX-CA15 in
the MusicCAST system, press
to reset the system.
When using the MCX-CA15 as
an amplifier for another system,
press RESET on the inside front
panel of the MCX-CA15 to reset
this unit.
TROUBLESHOOTING
Remedy
on the client for 10 seconds
.
on the client for 10 seconds
Refer to
page
Quick
Manual,
page 9
11
MCX-C15
Owner's
Manual,
page 43
—
6
6
29