Create Waypoint On Map; Navigate To A Waypoint - Eagle CUDA 350 S/MAP Installation And Operation Instructions Manual

Create Waypoint on Map

1. Use the arrow keys to move the cursor to the place where you want
to make a waypoint.
2. Press | . The waypoint is saved and automatically given a
WPT WPT
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map.
Create Waypoint by Entering a Position
, then use → to select
1. Press as the Subcategory| .
WPT N ENT
EW
2. Press ↓ to | |↑ to | .
E P ENT C ENT
NTERED OSITION REATE
3. Press ↓ to . Enter the latitude by pressing ↑ or ↓ to
|
L ENT
ATITUDE
change the first character, then press → to the next character and re-
peat until the latitude is correct. Press .
ENT
4. Press ↓ to | . Enter the longitude by pressing ↑ or ↓ to
L ENT
ONGITUDE
change the first character, then press → to the next character and repeat
until the longitude is correct. Press , then | to return to the
ENT EXIT EXIT
previous page display. The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map and in the waypoint list.

Navigate To a Waypoint

You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command. You, however, can avoid
scrolling the map to pick your waypoint if you use the Find Waypoint
commands:
1. Press |→ to | . To look up the nearest waypoint, press
WPT S ENT
AVED
or to look by name press ↓| . For this example, look by name.
ENT ENT
2. If your waypoint list is a long one, you can spell out the waypoint
name in the box. Press ↑ ↓ to change the first character,
F B N
IND Y AME
then press → to move the cursor to the next character and repeat until
the name is correct, then press to jump to the list below.
ENT
103