Setting The Interface Mode; Using Epsonnet Win/Mac/Webassist; Using Jumpers On The Print Server - Epson C12C824052 (Internal Type-B 10/100Base-T High Speed Ethernet Print Server User Manual

Setting the Interface Mode

The print server automatically selects an interface mode by
default. If you want to change the interface mode of the print
server, use EpsonNet Win/Mac/WebAssist or the jumpters on
the print server.

Using EpsonNet Win/Mac/WebAssist

See the following pages to change the interface mode of the print
server using EpsonNet Win/Mac/WebAssist:
To use EpsonNet WinAssist, see "Ethernet" on page 58.
To use EpsonNet MacAssist, see "Ethernet" on page 87.
To use EpsonNet WebAssist, see "Ethernet" on page 211.

Using jumpers on the print server

See the following steps to manually set an interface mode of the
print server using jumpers.
1. Turn off your printer. If you are using an ink jet printer,
unplug the power cord from the wall outlet.
2. Pull out the print server from the printer's interface slot, and
place it on an insulator such as a sheet.
3. Use the following table to change the jumper settings.
Note:
All of the jumpers are opened by default.
238
Troubleshooting