Table of Contents
Advertisement
If the printer power is off or there is a problem on the network,
the Get status every 20 sec check box is automatically
cleared. If this happens, make sure that the printer power is on
and the printer is correctly connected on the network, and then
select the Get status every 20 sec check box again.
5. Click OK to save settings.
6. When a message appears saying the settings are correctly
configured, click OK to start the Add Printer Wizard. Click
Next.
Note:
If you click Cancel and then later want to add the printer, start
the Add Printer Wizard and follow the steps below.
7. Click the Local printer radio button and click Next.
8. Select the printer driver and click Next.
If the following dialog box appears, select Replace existing
driver and click Next.
194
EpsonNet Internet Print
Advertisement
Table of Contents
